can i ise tactrix openport 2.0 to get car readings

I am probably missing something simple, but at the moment I can log a run (like the VAG cable). Log read and clear fault codes and access the other ecu's to read and clear fault codes, and to activate the Ayc pump and solenoids etc for bleeding the AYCĪnd also possibly download info from the ECU.

I read a few posts an here and thought that the Openport 2.0 would allow me to: With the VAG cable I can log runs, and play them back using Evoscan. I got the cable so I could do more than the VAG cable that I have (pin 1 and 4 connected to ground out pin 1) I have NO intention of flashing the ECU, I did not get the cable to flash the ECU. (My old Legnum was a 7201, I will check, but what I want to do is minimal so it would be more accessible if I had a 7202 or a 7203) I have checked the link to common tuning facts, but it is all about flashing! no answer to my questions!Īs far as I know I the have a 7201 ecu. I will download the other software you have mentioned (Ecuflash). I tried selecting AYC and MUTII AYC, but could not connect to ECU, could this be because I need to disconnect Pin 9?, (where is the best place to disconnect pin 9, in the openport plastic see through bit?, or use the openport OBDII extension and disconnect it there somewhere (sealed cable ends)) I checked for DTC's and I got the following:Īlso managed to log an engine tick over and rev with selected tick box options.ĭash only flashes when connecting to ECU.

I connected to the car, and I got a connection. I selected MutIII, EFI, and lower right, MutII EFI Right after installing the drivers, (or rather showing the laptop where to find them in the folders), I opened Evoscan 2.9 and I reconnected the 2.0 cable (it asked re drivers again, so I selected and it found them). Main thing I would like to know is:, Have I bought a duff cable?.ĭo I require different or additional software (ecuflash?, ECUEDIT,) to get them working?, I only have evoscan at the moment.Īny info or pointer would be most appreciated, :)Ĭable has Tactrix inc PoenPort 2.0 Rev E sticker on it. I have noticed that there are small led's in the OBDII connector part of the 2.o Cable, (clear plastic), and they seem to be steadily cycling through Blue, Green, Red (from left to right constantly. When I connect the cable to the OBDII port in the car, I dont get any flashing lights on the dash!.

I have tried various settings on evoscan, (mutII, OBDII, etc), and tried different versions of evoscan to try and connect, but no joy as yet!.Ĭan someone, tell me what version of evoscan I should be using with an openport 2.0 cable, and what settings to set evoscan to to get them working please. I have bought a tactrix openport cable and I have various versions of Evoscan, (2.1 2.5 2.6 2.7 &2.9), I just got the cable this week, and can't actuate anything or read fault codes.

Can i ise tactrix openport 2.0 to get car readings